The security provided by this product is totally dependant on the skill off the user. The user should have the experience to assess the following:

A)The suitability of this product for its intended use.
B) The reliability of the rock anchor or belay point.
C) The expecteddirection of loading.
D) That there are no edges or projections that could damage the product when under load.

Be aware that this equipment can be damaged in a fall and consequently should always be examined for defects before reuse. If this equipment exhibits signs of wear or defect or if there is any doubt about its serviceability, replace it. It is recommended that any equipment involved in a serious fall should be replaced. Where practical a history of use and inspection record should be kept. Wearing a climbing helmet will help protect your head from injury if you fall. When using belay techniques we recommend the use of appropriate gloves. Foresee and take appropriate action in situations where rescue may be required.

Temperature
Always keep products made wholly or partially from textile elements below 50 C as the performance of the nylon from which they are made may be affected at temperatures above this. Tests down to -40 C show no permanent change in the performance of this material although nylon may stiffen while at temperatures below 0 C.

Sea Water
It is essential that this equipment is cleaned as soon as is practical after exposure to sea water or any saline environment (e.g. when used on sea cliffs).

Chemicals and Corrosive Reagents
Avoid all contact with chemical reagents as they will affect the performance of this product (e.g. vehicle battery acid, bleach etc.). Discard this product immediately if contact has or is suspected to have occurred (the product may be permanently weakened without showing any signs).

Maintenance
This product is not user maintainable with the exception of cleaning.

Cleaning
First rinse the product in clean cold water of domestic supply quality. If still soiled rinse in warm water (max temperature 40C) with pure soap. Thoroughly rinse and dry naturally in a warm ventilated room away from direct heat.